3D Hobby Shop YAK55 Panduan Perakitan - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Perakitan untuk Mainan 3D Hobby Shop YAK55. 3D Hobby Shop YAK55 19 halaman.

-- Slide the horizontal stabilizer into the fuselage slot. Use a ruler to measure each side to make sure that it is centered.

-- Locate the carbon wing-spar tube and slide it into the fuselage. Measure each of the rear corners of the stabilizer to

the wing tube as shown. Adjust the stabilizer until each side measures exactly the same to correctly align the stabilizer.

-- Apply thin CA glue to the joint of the horizontal stabilizer and fuselage as shown. Allow the thin CA to run along the

joint and wick into the joint. NOTE: it is not necessary to remove any covering on the stabilizer.