3D Hobby Shop YAK55 조립 설명서 - 페이지 5

{카테고리_이름} 3D Hobby Shop YAK55에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Hobby Shop YAK55 19 페이지.

-- Slide the horizontal stabilizer into the fuselage slot. Use a ruler to measure each side to make sure that it is centered.

-- Locate the carbon wing-spar tube and slide it into the fuselage. Measure each of the rear corners of the stabilizer to

the wing tube as shown. Adjust the stabilizer until each side measures exactly the same to correctly align the stabilizer.

-- Apply thin CA glue to the joint of the horizontal stabilizer and fuselage as shown. Allow the thin CA to run along the

joint and wick into the joint. NOTE: it is not necessary to remove any covering on the stabilizer.