Aroma ACJ-260 Buku Petunjuk & Resep Jus - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk & Resep Jus untuk Peralatan Dapur Aroma ACJ-260. Aroma ACJ-260 12 halaman.

Halaman Cetak

START EXTRACTING JUICE

1. Rinse and clean vegetables and fruits thoroughly first. Peel and remove core if

needed. Cut food into small pieces for fitting into the feeding channel of the

protective cover. (We suggest to cut food no bigger than 2" long and ¾" wide;

slightly adjust the size of food for it to fit the channel.)

2. Turn switch to ON position. Use food plunger to press down fruits and vegetables

GENTLY into juice extractor. Process soft-textured fruits first (such as melon and

peach), followed by firmer fruits and vegetables (such as carrots and celery).

IMPORTANT: Do not force the food into the cutter/strainer, instead, use firm but

moderate pressure.

3. Use juice collector to collect juice.

4. To empty the pulp container: turn juice extractor to OFF position. Use handle to

remove the pulp collector and discard the pulp. Rinse the container with water and

put it back to the place. For best results, empty pulp container when it is ¾ filled.

JUICING TIPS

•

Hand form leafy vegetables such as spinach and parsley into compact (ball) shapes

first, and feed into the feeding channel.

Always serve juice immediately. The vitamin content of juice decreases when juices

•

are stored. If necessary, cover the juice container tightly with food wraps and store it

in refrigerator. Do not store over 24 hours.

Add a few spoonfuls of lemon juice in your juice collector before juicing to keep

•

juices from discoloring.

•

When preparing large quantity of fruits and vegetables to make juice, check pulp

container after processing 2 lbs. of food.

Do not use this juice extractor to extract juices from avocado, banana and

•

raspberries.

•

Use layers of cheesecloth to filter juice if clear juice is desired.

When processing moist, leafy vegetables or extract a large amount of fruits and

•

vegetables, the area between the cutter/strainer and the separating unit may

become clogged. If the juice extractor becomes clogged or vibrates excessively,

turn the unit to OFF position, unplug cord and allow the cutter/strainer to stop

completely. Empty the pulp completely and replace cover and fasten the cover

latches. It is now ready to continue to process juice.

IMPORTANT NOTE:

•

Always make sure that the cutter/strainer is securely placed on the

separating unit and the motor base in order to have the juice extractor

function properly.

•

Some pulp remaining in juice is normal, which increases the nutritive

value of the juice.