DiscreteHeat ThermaCurve Panduan Petunjuk Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pemanas DiscreteHeat ThermaCurve. DiscreteHeat ThermaCurve 20 halaman.

Installing the Power Connection PCB

Bracket

1. Mount the 'Easy Bend' PCB bracket

approx. 25mm (1") from the corner

of the wall/start of run, and up to the

ceiling. Do not over-tighten the 2

mounting screws so the bracket can

still slide on the slots. For mid-wall

installation, see separate instructions

provided.

Wall Bracket

4. The Wall bracket is fixed using the

centre slot (with teeth) and the oval

washer. Check its secured.

Bend here 90

2. When secure. Bend the bottom edge

up at 45° to form the angled bracket.

Oval Washer

Round Washer

5. The ceiling bracket is secured (but

slides) using the lower slot (no teeth)

and the round washer. Check bracket

still slides.

Bed up to 45

~200mm/8"

3. Installing the 1st Wall & Ceiling

Brackets.

6. 2nd & 3rd Brackets.

The 2nd set of brackets is fitted in the

middle wall length. The 3rd set is fitted

~200mm from the end/ corner of the

wall.

~225mm/9"

~250mm/10"

250 mm

200 mm

Middle of wall