DiscreteHeat ThermaCurve Panduan Petunjuk Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Pemanas DiscreteHeat ThermaCurve. DiscreteHeat ThermaCurve 20 halaman.

Halaman Cetak

Preparing the cable lengths (if not

supplied factory cut)

Power Connection /

PCB

Wall length

MINUS

-100mm/4''

Or: Profile Length

PLUS

+100mm/4''

Preparing the Power Connection Cable

end

Note: Heating cables are usually supplied pre-prepared. If not, prepare the cable ends before inserting into the

ThermaCurve profile; the cable is difficult to strip and mistakes are hard to correct once the cable is in the cable channels.

80mm

1. Remove the outer red silicone jacket

to reveal approximately 80mm (3 ¼") of

black inner core.

Internal Corner

External corner

Wall length

MINUS

-25mm/1''

Or: Profile Length

PLUS

+100mm/4''

2. Split the black inner core down the

middle and separate.

Special Angle

Wall length

PLUS

+25mm/1''

-25mm/1''

Or: Profile Length

PLUS

+50mm/2''

+125mm/5''

3. Using a Stanley knife (box cutter)

or similar at a shallow angle, slice

away the black core to reveal the inner

conductors; NOTE; safety gloves and

eye shields should be worn and always

cut away from yourself.

End Termination

Wall length

MINUS

-50mm/''

Or: Profile Length

PLUS

+50mm/2''

25mm