Arometrix FRACTION FINDER Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Laboratorium Arometrix FRACTION FINDER. Arometrix FRACTION FINDER 17 halaman.

3. Insert the sensor cable into the back of the sensor.

4. Connect the other end of the sensor cable to the monitor. The sensor's light will begin to "blink",

indicating that it has turned on. Give the sensor ~2-5 minutes to boot up.

5. Mount the monitor.

6. Power the monitor.

7. The monitor will take a few seconds to turn. You will see splash screens, followed by the interface

screen.

8. Ensure that the Device Status and Server Status indicator on the bottom left-hand side of the

monitor are green – If not, make sure the cords are properly connected.

9. Ensure that the "Light On/Light Off" toggle button is turned on. The light above it should be green.

Section 5: Understanding the Interface

After installation, the system is ready for immediate operation.

Different Viewing Options

There are currently two viewing options: the Spectrum view and the Wavelength view. These display

options can be toggled between each other by tapping the "display" button (located in the top-left corner).

What it

does:

This is an instantaneous representation of the current spectral state. It displays the current

background/ambient light corrected spectral measurement.

Important Note:

The peak at 360-390nm is an internal excitation/reference peak (not a process indicator);

tap the small circle on the top-left corner of the graph to remove this peak

Understanding the Graph (X-Y Axis)

Arometrix, Inc.

Spectrum View (Spectrograph)

arometrix.com/resources