Dispens-a-Matic Bottle-Matic II Informasi dan Instruksi
Jelajahi secara online atau unduh pdf Informasi dan Instruksi untuk Peralatan pengemasan Dispens-a-Matic Bottle-Matic II. Dispens-a-Matic Bottle-Matic II 3 halaman. Labeler / applicator
Halaman CetakBottle-Matic II Label Information and Instructions.
Labels should be wound on 3" cores with the core extending all the way to the edge of the roll. The
recommended copy position for printed labels is number 3 or 4 (see diagram below). This determines which
way the label dispenses off of the roll. Labels must be die-cut with a 1/8" (or more) gap. Narrow labels will
work but the backing paper for them must be at least 1 ½" inches wide.
There are two 11" long, 1/16" aluminum roll guides and (1) tension spring with the machine. These guides
should be placed on either side of the roll of labels between the metal core inserts and the locking collar. The
notches on the end of the guide slide onto the chrome rod at the bottom of the machine. One tension spring goes
between the right roll guide and the locking collar on the right side of the roll of labels.
March 22, 2011
Page | 1