Dispens-a-Matic Bottle-Matic II 정보 및 지침
{카테고리_이름} Dispens-a-Matic Bottle-Matic II에 대한 정보 및 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dispens-a-Matic Bottle-Matic II 3 페이지. Labeler / applicator
페이지 인쇄Bottle-Matic II Label Information and Instructions.
Labels should be wound on 3" cores with the core extending all the way to the edge of the roll. The
recommended copy position for printed labels is number 3 or 4 (see diagram below). This determines which
way the label dispenses off of the roll. Labels must be die-cut with a 1/8" (or more) gap. Narrow labels will
work but the backing paper for them must be at least 1 ½" inches wide.
There are two 11" long, 1/16" aluminum roll guides and (1) tension spring with the machine. These guides
should be placed on either side of the roll of labels between the metal core inserts and the locking collar. The
notches on the end of the guide slide onto the chrome rod at the bottom of the machine. One tension spring goes
between the right roll guide and the locking collar on the right side of the roll of labels.
March 22, 2011
Page | 1