arpha D01 Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kunci arpha D01. arpha D01 11 halaman.
Halaman CetakConnection Column
Screw
Round Head
Screws
Front Panel Screw
4. Install the back panel
a. Remove the back cover, route the connection wire through the
back panel, and straighten.
b.Turn the KNOB to the vertical position and align the pick to the
door.
c. Turn the KNOB to check the latch switch is ok.
d. Fix with the back panel screws(M4 * 0.4inch) in the battery box
and 1 back panel screw(M4*1inch).
e. Insert the connection wire interface into the back panel.
f. Install 4 AA batteries and the battery cover.
Connection Wire
Interface
Back Cover
Back Panel Screw
(M4 * 0.4inch)
Flat Head
Screws
06
Paddle
KNOB: Vertical
Back Panel Screw
(M4*1inch)
Lock Calibration
1. Reset Lock: Long press 'Reset' button for 3 seconds, back to the
factory default settings.
2. when the voice prompt 'Di' and the "
turn the KNOB to the horizontal position, then the voice
'successful' appears.
3. Activate Auto-Lock Function: Take the keys with you, then
close the door. Press '7
' and it will automatically lock when
the door is closed.
Basic Functions
1. Add administrator (The first two users are
administrators)
· Short press "reset" button or any key to wake up the keyboard,
long press '
'
· Enter the administrator pin password (6~8 digits) ended
with '
', enter the same password again. Then the voice
"successful" appears.
· Set the 2nd administrator (pin password or fingerprint), just like
the steps above.
· When the voice says "the administrator is full", it means you've
set 2 administrator password already.
Note: Make sure to press different parts of the same finger until
the whole finger data is collected completely. The lock
keyboard '1~3' will light on when added successfully.The
improper operation will increase the input times.The
administrator password is very essential for some special
settings, please keep it in mind.
" button is solid on,
07