arpha D01 User Manual - Page 5

Browse online or download pdf User Manual for Locks arpha D01. arpha D01 11 pages.

Print Page

Connection Column

Screw

Round Head

Screws

Front Panel Screw

4. Install the back panel

a. Remove the back cover, route the connection wire through the

back panel, and straighten.

b.Turn the KNOB to the vertical position and align the pick to the

door.

c. Turn the KNOB to check the latch switch is ok.

d. Fix with the back panel screws(M4 * 0.4inch) in the battery box

and 1 back panel screw(M4*1inch).

e. Insert the connection wire interface into the back panel.

f. Install 4 AA batteries and the battery cover.

Connection Wire

Interface

Back Cover

Back Panel Screw

(M4 * 0.4inch)

Flat Head

Screws

Paddle

KNOB: Vertical

Back Panel Screw

(M4*1inch)

Lock Calibration

1. Reset Lock: Long press 'Reset' button for 3 seconds, back to the

factory default settings.

2. when the voice prompt 'Di' and the "

turn the KNOB to the horizontal position, then the voice

'successful' appears.

3. Activate Auto-Lock Function: Take the keys with you, then

close the door. Press '7

' and it will automatically lock when

the door is closed.

Basic Functions

1. Add administrator (The first two users are

administrators)

· Short press "reset" button or any key to wake up the keyboard,

long press '

· Enter the administrator pin password (6~8 digits) ended

with '

', enter the same password again. Then the voice

"successful" appears.

· Set the 2nd administrator (pin password or fingerprint), just like

the steps above.

· When the voice says "the administrator is full", it means you've

set 2 administrator password already.

Note: Make sure to press different parts of the same finger until

the whole finger data is collected completely. The lock

keyboard '1~3' will light on when added successfully.The

improper operation will increase the input times.The

administrator password is very essential for some special

settings, please keep it in mind.

" button is solid on,