Distech Controls Allure ECB-103 Panduan Instalasi - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Pengontrol Distech Controls Allure ECB-103. Distech Controls Allure ECB-103 16 halaman.
Juga untuk Distech Controls Allure ECB-103: Panduan Instalasi (16 halaman)
Halaman Cetak
For controllers embedding a pre-loaded application, commissioning can be used to perform application selection if needed. Pre-loaded applications are
factory-loaded programs that enable the controller to control a typical equipment. See the Pre-Loaded Application User Guide for more information.
For ECB Series controllers only, during commissioning, the Allure EC-Smart-Vue sensor is used to set the controller's BACnet
connected ECB Series controller's MAC Address as follows:
Set the connected controller's MAC Address as follows:
1. Connect an Allure EC-Smart-Vue Series Communicating Sensor to the controller with a Cat 5e patch cable. Wait for the display to show the room
temperature.
2. Press and hold the Menu button
3. Use the down button
to set the number to 9995 (this is the default password).
4. Press the Menu button
5. Press the down button
dress.
6. Use the up and down buttons
7. Press the Menu button
8. Press and hold the Menu button
Once the controller's network is operational, the controller can be programmed with EC- gfx Program. For each Allure EC-Smart-Vue Series Communicat-
ing Sensor, set its Subnet ID number to the block number of its associated ComSensor block in EC- gfx Program. This is done in the sensor's GEN CFG
menu under SUBNET ID.
for 5 seconds to enter the password menu. 10000 is shown on the display.
Screen Timeout: 15 seconds
Screen Timeout: 15 seconds
to submit the password. Upon submitting the password, the GEN CFG menu appears on the display.
Screen Timeout: 30 seconds
once to enter the GEN CFG submenu. The MAC ADDRESS menu is shown with the current controller's BACnet MAC Ad-
Screen Timeout: 30 seconds
to set the controller's MAC Address. Only addresses from 1 to 127 are recommended to be used.
once to apply the value.
for 5 seconds to exit the configuration menu.
OR
OR
OR
OR
®
MAC Address. Set the
9 / 16