CAME RIO SYSTEM Manual - Halaman 9

Jelajahi secara online atau unduh pdf Manual untuk Pembuka Pintu Garasi CAME RIO SYSTEM. CAME RIO SYSTEM 16 halaman.

Halaman Cetak
CAME RIO SYSTEM Manual
Technical data
Type
Power supply (V DC)
Stand-by absorption (μA)
Current draw in transmission (mA)
two, lithium CR123A (mAh) batteries
Battery life (months)*
Radio frequency (MHz)
Radio range over clear areas (m)**
Storage temperature (°C)***
Average product life (cycles)****
Transmission power (dBm)
Materials
(*)The battery duration is calculated on a yearly average of 20 daily-
maneuvers.
(**)Do not place the RIOCN8WS or the RIOCT8WS card behind walls,
metal fences or any other obstructions that could interfere with radio
communications.
(***) Before installing the product, keep it at room temperature where
it has previously been stored or transported at a very high or very low
temperature.
(****) The average product life is a purely indicative estimate. It applies
to compliant usage, installation and maintenance conditions. It is
also infl uenced by other factors, such as climatic and environmental
conditions.
FA01702M4A
FA01702M4A
-
-
06/2022
06/2022
Installing
⚠ Fit the RIOLX8WS photocells near the RIOCN8WS or the RIOCT8WS
RIOLX8WS
card, so as not to have any metal or cement obstructions.
3
- Fasten the base ⑦ onto the chosen surface. When fi tting the device
80
to a wall, you will need to use THE KIAROS BRACE ⑨ (not supplied).
- Fit the card ⑤ into the base ⑦ and fasten using the supplied screws
15
④.
1700
NB: Do not change the antenna's position.
24
- Save, the RIOLX8WS transmitter and receivers , ON the RIOCT8WS or
the RIOCN8WS CONTROL CARD (SEE THE SAVING CHAPTER).
868.95
- Make the necessary functional checks (see the manual FOR the
30 max.
RIOCT8WS OR THE RIOCN8WS).
- Finish assembling the RIOLX8WS fl ashing light.
-25 ÷ +70
Saving
100,000
Fit the batteries into all accessories that will be saved.
10 max.
⚠After three minutes, the devices shift into stand-by mode; to
PC-ABS
reactivate them, press T1 or T2 for one second.
Check that the CH1 and CH2 LEDs are fl ashing red simultaneously,
otherwise do a reset (see THE RESETTING PROCEDURE).
Saving T1
Press, for one second, the T1 button on the RIOLX8WS card: the CH1
and CH2 LEDs will fl ash red in alternation. Press, for one second,
the PROG button on the RIOCN8WS card or the RIOCT8WS card: the
WIRELESS LEDs, on the RIOCN8WS or the RIOCT8WS card, will switch
from fl ashing to off , and the CH1 LED on the RIOLX8WS card will fl ash
blue once and then switch off .