CAME RIO SYSTEM Handmatig - Pagina 9

Blader online of download pdf Handmatig voor {categorie_naam} CAME RIO SYSTEM. CAME RIO SYSTEM 16 pagina's.

Pagina afdrukken
CAME RIO SYSTEM Handmatig
Technical data
Type
Power supply (V DC)
Stand-by absorption (μA)
Current draw in transmission (mA)
two, lithium CR123A (mAh) batteries
Battery life (months)*
Radio frequency (MHz)
Radio range over clear areas (m)**
Storage temperature (°C)***
Average product life (cycles)****
Transmission power (dBm)
Materials
(*)The battery duration is calculated on a yearly average of 20 daily-
maneuvers.
(**)Do not place the RIOCN8WS or the RIOCT8WS card behind walls,
metal fences or any other obstructions that could interfere with radio
communications.
(***) Before installing the product, keep it at room temperature where
it has previously been stored or transported at a very high or very low
temperature.
(****) The average product life is a purely indicative estimate. It applies
to compliant usage, installation and maintenance conditions. It is
also infl uenced by other factors, such as climatic and environmental
conditions.
FA01702M4A
FA01702M4A
-
-
06/2022
06/2022
Installing
⚠ Fit the RIOLX8WS photocells near the RIOCN8WS or the RIOCT8WS
RIOLX8WS
card, so as not to have any metal or cement obstructions.
3
- Fasten the base ⑦ onto the chosen surface. When fi tting the device
80
to a wall, you will need to use THE KIAROS BRACE ⑨ (not supplied).
- Fit the card ⑤ into the base ⑦ and fasten using the supplied screws
15
④.
1700
NB: Do not change the antenna's position.
24
- Save, the RIOLX8WS transmitter and receivers , ON the RIOCT8WS or
the RIOCN8WS CONTROL CARD (SEE THE SAVING CHAPTER).
868.95
- Make the necessary functional checks (see the manual FOR the
30 max.
RIOCT8WS OR THE RIOCN8WS).
- Finish assembling the RIOLX8WS fl ashing light.
-25 ÷ +70
Saving
100,000
Fit the batteries into all accessories that will be saved.
10 max.
⚠After three minutes, the devices shift into stand-by mode; to
PC-ABS
reactivate them, press T1 or T2 for one second.
Check that the CH1 and CH2 LEDs are fl ashing red simultaneously,
otherwise do a reset (see THE RESETTING PROCEDURE).
Saving T1
Press, for one second, the T1 button on the RIOLX8WS card: the CH1
and CH2 LEDs will fl ash red in alternation. Press, for one second,
the PROG button on the RIOCN8WS card or the RIOCT8WS card: the
WIRELESS LEDs, on the RIOCN8WS or the RIOCT8WS card, will switch
from fl ashing to off , and the CH1 LED on the RIOLX8WS card will fl ash
blue once and then switch off .