Altman GALLERY SERIES Panduan Memulai Cepat - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Peralatan Pencahayaan Altman GALLERY SERIES. Altman GALLERY SERIES 20 halaman.

Gallery Series

Accessory Holder - All Models

All Gallery Series LED Luminaires have a end of lens accessory holder. This holder is easily opened to

accept such optional accessories (all sold separately or by others) as:

• 4-Flap Barn Doors

• Top Hat

• Half Top Hat

• Color (Gel) Frame

To open the accessory holder, as illustrated in Figure 16, remove the thumb screw holding the accessory

holder clamp and insert the accessory. Once the accessory is inserted, reinstall the accessory holder

clamp and screw.

Pan & Tilt - All Models

All Gallery Series LED Luminaires can have their pan and tilt set by hand (without the use of tools).

To adjust pan or tilt, loosen (do not remove) thumb screw or knob as indicated in Figure 18 and adjust pan

or tilt as desired. Once positioned as desired, re-tighten, by hand or tool (see note on tilt knob), the thumb

screw or knob. Do not over tighten!

Note: All Gallery Series LED Luminaires are fitted with pan and tilt stop studs. The stops prevent

the fixture head from panning or tilting beyonds it limits for internal wiring travel. It is important

that these stops are never removed from the fixture or internal wiring damage may occur.

Pan Thumb Screw

Figure 18: Fixture Pan & Tilt

Accessory Holder Thumb Screw

Accessory Holder Clamp

Note: Beam Wash model shown,

same for all models.

Figure 17: Accessory Holder - All Models

Quick Start Guide

Pan Stop (See Note Below)

Tilt Knob (See Note Below)

*A small screwdriver can

be inserted into knob hole

to tighten if desired.

Page 19