3DLab GANG PRINT BEAT PZL p.11c Panduan Pengguna - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mainan 3DLab GANG PRINT BEAT PZL p.11c. 3DLab GANG PRINT BEAT PZL p.11c 19 halaman. Polish fighter
Halaman Cetak
member of Group
TAILPLANE
Horizontal tailplane: into the fuselage part (1) cement the hexagonal pins (47), then glue tailplane parts (37-
38) and (41-42), which you attach to hexagonal pins and glue the whole together with the struts (48-49) to the
fuselage (1)
Elevators: join port (left) elevator parts (39-40) then starboard (right) parts (43-44-45), connect both parts
together with the axle(46), make sure that the pieces are in plane, install the hinges in place and stick them into
the taiplane that you already have attached to the rear fuselage part (1)
Note: It is necessary to draw out the servo bowden wire and attach it to the elevator just before you join it with
the horizontal tailplane.
12