3DLab GANG PRINT BEAT PZL p.11c 사용자 설명서 - 페이지 13

{카테고리_이름} 3DLab GANG PRINT BEAT PZL p.11c에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DLab GANG PRINT BEAT PZL p.11c 19 페이지. Polish fighter

member of Group

TAILPLANE

Horizontal tailplane: into the fuselage part (1) cement the hexagonal pins (47), then glue tailplane parts (37-

38) and (41-42), which you attach to hexagonal pins and glue the whole together with the struts (48-49) to the

fuselage (1)

Elevators: join port (left) elevator parts (39-40) then starboard (right) parts (43-44-45), connect both parts

together with the axle(46), make sure that the pieces are in plane, install the hinges in place and stick them into

the taiplane that you already have attached to the rear fuselage part (1)

Note: It is necessary to draw out the servo bowden wire and attach it to the elevator just before you join it with

the horizontal tailplane.