3DLab GANG PRINT BEAT PZL p.11c 사용자 설명서 - 페이지 14

{카테고리_이름} 3DLab GANG PRINT BEAT PZL p.11c에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DLab GANG PRINT BEAT PZL p.11c 19 페이지. Polish fighter

member of Group

ENGINE PART - ELECTRIC MOTOR ATTACHMENT

Engine part: Fit the electric motor holder (11) into the fuselage part (5) so that the Print Beat logo is properly

legible, then adjust correct setting of the motor holder by insertion or removing according to the size of your

electric motor (then ﬁx it by Super Glue).

Engine model: Install 9x engine cylinder (12) to part (8), then insert the engine cooling ring (10) – now it is the

right moment to install the electronic parts (regulator and electric motor). Then ﬁx the assembly by the screw to

the fuselage part (5) and it remains to cover battery opening by the cover (9).

Propeller spinner: Put the propeller onto the mounting disc and insert the spinner (60), then put a nut into the

part (62) – the propeller unit is complete.

Note: You can make a choice of two used sizes of the mounting disc.

Congratulation if you ﬁnished this part of the model assembly and you have the fuselage complete. Now you

must still assemble the wing parts.