Divesoft ODA Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Instrumen Selam Divesoft ODA. Divesoft ODA 16 halaman.

How to connect ODA and put it in to operation

The ODA is equipped with a connector identical to the HUD or Buddy Display connector .

Theoretically, it is possible to connect ODA to the left and right CU, but the cable routing

determines a more advantageous connection to the right CU and the cable routing along the

right corrugated hose .

Before installing the ODA connector to the Liberty head, make sure that there is an O-ring seal

on the connector and that it is well lubricated . Secure the connector in the head with the two

enclosed screws using a 3 mm Allen key .

Wrap the ODA cable around the corrugated hose so that it does not form excess loops and is

not too short that head movements are restricted .

IMPORTANT: ODA must be assigned an indication using a handset . On the handset in the main

menu, select Setup / Preferences / Indication . For Left and Right, Buddy D ., HUD, ODA, and None

are selected . Depending on the actual ODA location (left CU, Right CU), select the ODA value for

the item . Without this setting, ODA does not work!

Recommendation: If you use only one handset in conjunction with ODA, have ODA on the

opposite CU than the handset . This allows you to back up the displayed information in the event

of a failure of one of the CUs or batteries .