3DUpFitters CR-10 Smart Enclosure Kit Panduan Instalasi - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Printer 3D 3DUpFitters CR-10 Smart Enclosure Kit. 3DUpFitters CR-10 Smart Enclosure Kit 19 halaman.

Halaman Cetak

9. Sealing Gaps

Once the enclosure is completely put together, it is time to make sure that each of the

panels is held tightly to each adjoining panel. The connectors are designed with a

small amount of play that allows you to make small adjustments for the perfect ﬁt.

1. Loosen screws on the panel to move.

2. Push that panel into place. You may need a friend to hold it tightly in the right spot.

3. Re-tighten the screws to hold the panel. Only tighten enough to hold the pieces

snuggly. DO NOT OVER-TIGHTEN! These parts are sturdy, but they're still all made

out of plastic..

Repeat the product, going around the enclosure looking to make sure all of the panels

are ﬂush to each other.

10. Filament

Filament is fed into the enclosure from a spool holder. It should sit on top of the

enclosure on the end approximately where the ﬁlament spool would have been

oriented without an enclosure. Of course, if you didn't purchase our spool holder you

are free to use whatever type of freestanding spool holder you wish; there are

hundreds of designs available on Thingiverse.