ESI ESCTDEB Panduan Petunjuk Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Termostat ESI ESCTDEB. ESI ESCTDEB 16 halaman. Electronic dual cylinder thermostat
Juga untuk ESI ESCTDEB: Petunjuk Pengguna (8 halaman)

Halaman Cetak

should be made aware that once a week the hot

water will be warmer following the automatic "weekly

boost". We also therefore strongly recommend the use of a

thermostatic mixing valve (TMV), these blend hot water with

cold water to ensure constant safe shower and bath outlet

temperatures, preventing scalding.

Adjusting and Resetting the Cylinder Thermostat

Adjust the dial to show the desired hot water temperature on

the display, between 25°C to 65°C. The lower the temperature,

the less chance of scalding and the more energy saving. Most

homeowners find a temperature between 48°C-53°C to be

adequate. If the system should overheat, the cause must be

determined and resolved by a suitably qualified person. In the

event of an overheat, the thermostat cuts out automatically.

The reset for the thermostat is under the adjustment dial.

Adjusting the 1 Hour Boost

The ESCTDEB has user defined settings where the duration

of the Legionella Override can be adjusted from 1 to 7 days

or completely disabled to operate as a conventional Dual

Cylinder Thermostat.

1. To disable/adjust the legionella boost turn the unit off

by pressing and holding down the HOLIDAY button

until an audible click is heard and the red LED turns off.

2. Release the button and after approx. 10 seconds press

and hold the HOLIDAY button again. After 5 seconds

the red LED will light up and an audible click is heard,

keep the HOLIDAY button pressed for a further 5

seconds until the LCD display flashes.

3. Release the button and use the HOLIDAY button to

choose between disabling the override (OF) or setting

the delay between the overrides from 1 – 7 days.