Altox WBUS-4 v2 Panduan Operasional

Jelajahi secara online atau unduh pdf Panduan Operasional untuk Aksesori Mobil Altox WBUS-4 v2. Altox WBUS-4 v2 4 halaman.

General Guide for Installation

- Install the device as far as possible from metal parts and wiring

Altox

harnesses.

- Recommendation: connect device supply directly to the OBD-II connector

wires where pin 16 is +12В, pin 4 is GND (common).

- Auxiliary output OUT commutates at +12V. It is used to start heaters using

an analogous signal and to connect status LED located in the button from

the package, as well as to connect a coolant pump or the interior's heater

via a power relay.

Auxiliary output OUT is switched on with the delay (TIME2 setting) and/or

based on the coolant agent temperature (LTEMP1 setting) after the heater

is switched on. It is switched off with the delay (TIME3 setting) after the

heater is switched off.

- If there are other control units on the bus, it is recommended to connect

the module's control wire (blue) via normally open signaling relay

controlled by output OUT.

In this case you should activate setting SEPARLINE1 that activates this relay

before the data exchange.

O p e r a t i o n a l M a n u a l

- If you need to implement additional options of remote control of output

OUT (for example, to block engine remotely) activate setting SEPAROUT1.

It switches the output mode into manual control mode (SMS-commands:

ACTIVATE / DEACTIVATE).

ALTOX WBUS-4 v2

In this mode setting KEEPOUT1 activates option to save and to

subsequently restore of output OUT state when the module's power supply

is switched off and then switched on, respectively.

Please indicate the place of ALTOX module's location in the vehicle for

possible maintenance:

Authorized Service:

Installation Date: