Altronic CDM-2100 Panduan Pengoperasian - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Alat Ukur Altronic CDM-2100. Altronic CDM-2100 20 halaman. Differential pressure monitor
CALIBRATION protection. When protection is ON, the user is able to view the
menu values but not able to change them. If an attempt is made to change the
values and the ENTER key is pressed when protection is on, the display will read
PASSWORD PROTECTED! ENTER PASSWORD. This prompts the user to enter
the password. If the correct password is entered, the requested configuration
values can be changed.
To set or change a password, select SECURITY from the main menu and press
ENTER. If the password is set to 000, the security menu will be available without
entering the password. If the password is any number but 000, the proper
password must be entered to enter the security menu. Each of the security
selections can be turned ON or OFF individually. Use the or arrow key to
point to the item to be protected and press ENTER, the é arrow will change to
é. Use the or key to select either ON or OFF and press ENTER. The display
will show SAVED and the change will be saved to memory. When a menu item is
protected, the display will read ON, not protected will show as OFF. To enter a
password, point to PASSWORD and press ENTER. Use the or arrow key to
increase or decrease each of the 3-digit password numbers and press ENTER.
The display will show SAVED and the change will be saved to memory. Any
number from 000 to 999 can be used. Please note that Autoscan, Units, Filter
Values, and R eset cannot be locked out by security protection. Please note that
SECURITY protects both channels.
SECURITY:
CONFIG PROT
SETPNT PROT
COMM PROT
CAL PROT
~PASSWORD
PREVIOUS MENU
8.7.2
CONFIGURATION PROTECTION:
When set to ON, prevents the user from changing items in the CONFIGURE
menu. Items protected are TYPE (input sensor type), GAUGE LABEL, and
BARGRAPH.
8.7.3
SETPOINT PROTECTION:
When set to ON, prevents the user from changing the items in the SETPOINTS
menu. All setpoint values and configurations can be read but not changed.
8.7.4
COMMUNICATIONS PROTECTION:
When set to ON prevents the user from changing the Modbus registers via the
serial communications. User can read, but not write data. If the user attempts
to perform a write, the error message INVALID FUNCTION CODE will be sent.
8.7.5
CALIBRATION PROTECTION:
When set to ON, prevents user from changing calibration values.
8.7.6
PASSWORD:
The password is the second level of protection. When PASSWORD is selected,
the user will be prompted to enter a 3-digit password. To enter a password,
point to PASSWORD and press ENTER, the first digit will be underlined. Use
the or arrow key to increase or decrease that digit from 0 to 9 and press
ENTER. The next digit will be highlighted, use the same procedure to continue
to enter a 3-digit password and press ENTER to save. Any number from 000 to
999 can be used. The default password is 330.
With a password in memory, and the security screen is accessed, the
message PASSWORD PROTECTED! ENTER PASSWORD will appear. If the
proper password is entered, the security screen will be displayed and changes
will be allowed. To gain access to the protected menus without having to enter
a password, turn protection OFF. If the incorrect password is entered, the
display will return to the menu denying access to the protected menu.
CDM-2100 OM 3-21
All rights reserved © ALTRONIC, LLC 2021
ON
ON
ON
ON
000
9