AIMS Power PWRINV400W Buku Petunjuk - Halaman 6
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Inverter AIMS Power PWRINV400W. AIMS Power PWRINV400W 9 halaman. Dc to ac power inverter
•
If there is anything wrong with the inverter, disconnect all of the power and contact technical
support.
TROUBLESHOOTING
If the Inverter does not appear to be functioning properly, check the following possible causes:
•
Poor contact: Clean contact parts thoroughly.
•
If the low battery alarm sounds, this means the input voltage is too low and battery
needs to be recharged.
•
If you are getting a low output voltage, try reducing the load to minimize watts. You may have
overloaded the inverter. Reduce your load. Also, keep input voltage above 10.5 volts to
maintain a constant flow of power.
•
If you are not getting any power output, turn the power switch Off and On again, until the
green power light comes on. Your devices may draw too much power to operate them. The
inverter may be in thermal shutdown. Let it cool down and make sure there is adequate
ventilation around the unit.
•
If the green light turns red one of the following has happened:
A. input voltage is too low
B. input voltage is too high
C. short circuit
D. inverter is close to overload
•
Battery voltage is too low: Start the engine to recharge the battery. Replace or recharge
battery if needed.
•
Shuts down on overload: Reduce the wattage of your load.
•
Thermal shutdown: Under heavy loads for extended period, the inverter will shut
down to prevent damage from excess heat. Simply reduce your load and allow the
Inverter to cool down.
•
Low-battery shutdown: Recharge your battery and resume operation.
MAINTENANCE
Very little maintenance is required to keep your inverter operating properly. You
should disconnect input power first and then clean the exterior of the unit
periodically with a dry cloth to prevent accumulation of dust and dirt. At the same
time, tighten the screws on the DC input terminals.
PLEASE READ THE FOLLOWING CAREFULLY
Neither the manufacturer nor distributor makes any representation or warranty of any kind to the
buyer that he or she is qualified to make any repairs to the product or that he or she is qualified to
replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all