AIMS Power PWRINV400W 사용 설명서 - 페이지 6

{카테고리_이름} AIMS Power PWRINV400W에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AIMS Power PWRINV400W 9 페이지. Dc to ac power inverter

•

If there is anything wrong with the inverter, disconnect all of the power and contact technical

support.

TROUBLESHOOTING

If the Inverter does not appear to be functioning properly, check the following possible causes:

•

Poor contact: Clean contact parts thoroughly.

•

If the low battery alarm sounds, this means the input voltage is too low and battery

needs to be recharged.

•

If you are getting a low output voltage, try reducing the load to minimize watts. You may have

overloaded the inverter. Reduce your load. Also, keep input voltage above 10.5 volts to

maintain a constant flow of power.

•

If you are not getting any power output, turn the power switch Off and On again, until the

green power light comes on. Your devices may draw too much power to operate them. The

inverter may be in thermal shutdown. Let it cool down and make sure there is adequate

ventilation around the unit.

•

If the green light turns red one of the following has happened:

A. input voltage is too low

B. input voltage is too high

C. short circuit

D. inverter is close to overload

•

Battery voltage is too low: Start the engine to recharge the battery. Replace or recharge

battery if needed.

•

Shuts down on overload: Reduce the wattage of your load.

•

Thermal shutdown: Under heavy loads for extended period, the inverter will shut

down to prevent damage from excess heat. Simply reduce your load and allow the

Inverter to cool down.

•

Low-battery shutdown: Recharge your battery and resume operation.

Very little maintenance is required to keep your inverter operating properly. You

should disconnect input power first and then clean the exterior of the unit

periodically with a dry cloth to prevent accumulation of dust and dirt. At the same

time, tighten the screws on the DC input terminals.

PLEASE READ THE FOLLOWING CAREFULLY

Neither the manufacturer nor distributor makes any representation or warranty of any kind to the

buyer that he or she is qualified to make any repairs to the product or that he or she is qualified to

replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all