dji PHANTOM Panduan Memulai Cepat - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Drone dji PHANTOM. dji PHANTOM 14 halaman. Led indicator description & faq
Juga untuk dji PHANTOM: Panduan Memulai Cepat (17 halaman), Panduan Memulai Cepat (8 halaman), Panduan Lanjutan (6 halaman), Panduan Memulai Cepat (3 halaman), Manual (6 halaman), Panduan Memulai Cepat (3 halaman), Pemasangan (2 halaman)

Enhanced Fail-safe

Enhanced Fail-safe will be triggered when the MC loses the control signal, there are following situations.

Signal lost between the transmitter and receiver, e.g. multi-rotor is out of the communication range, or

transmitter is down, and so on.

One or more connections of A, E, T, R, U channels between main controller and receiver loses. If this

happens before take-off, motors will not work if you push the throttle stick; if this happens during the

flight, LED yellow light will flash to warn in addition to the failed-safe method.

The multi rotor will automatically land if the fail-safe mode is active, or return home if in GPS mode.

Before takeoff, current position will be saved as home point by MC automatically when you push the

throttle stick first time after 6 or more GPS satellites are found (red LED blinks once or no blink) 8 seconds.

Make sure to save the home location before takeoff and keep it in mind clearly for safe reasons.

When switch to Manual Mode or Atti. Mode, MC will disengage enhanced failed-safe mode, you can

re-gain control of multi-rotor.

The following schematic shown is introduction for Go-Home and Landing.

The aircraft will not go home if the GPS signal is not good; or the distance between the Home Location

and multi-rotor is less than 25m and the altitude is lower than 20m relative to the Home Location.

10 |