dji PHANTOM 빠른 시작 매뉴얼 - 페이지 10

{카테고리_이름} dji PHANTOM에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dji PHANTOM 14 페이지. Led indicator description & faq
dji PHANTOM에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (17 페이지), 빠른 시작 매뉴얼 (8 페이지), 사전 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (3 페이지), 매뉴얼 (6 페이지), 빠른 시작 매뉴얼 (3 페이지), 마운팅 (2 페이지)

Enhanced Fail-safe

Enhanced Fail-safe will be triggered when the MC loses the control signal, there are following situations.

Signal lost between the transmitter and receiver, e.g. multi-rotor is out of the communication range, or

transmitter is down, and so on.

One or more connections of A, E, T, R, U channels between main controller and receiver loses. If this

happens before take-off, motors will not work if you push the throttle stick; if this happens during the

flight, LED yellow light will flash to warn in addition to the failed-safe method.

The multi rotor will automatically land if the fail-safe mode is active, or return home if in GPS mode.

Before takeoff, current position will be saved as home point by MC automatically when you push the

throttle stick first time after 6 or more GPS satellites are found (red LED blinks once or no blink) 8 seconds.

Make sure to save the home location before takeoff and keep it in mind clearly for safe reasons.

When switch to Manual Mode or Atti. Mode, MC will disengage enhanced failed-safe mode, you can

re-gain control of multi-rotor.

The following schematic shown is introduction for Go-Home and Landing.

The aircraft will not go home if the GPS signal is not good; or the distance between the Home Location

and multi-rotor is less than 25m and the altitude is lower than 20m relative to the Home Location.

10 |