dji Inspire 1 Panduan Memulai Cepat - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Quadcopters dji Inspire 1. dji Inspire 1 11 halaman.
Juga untuk dji Inspire 1: Panduan Memulai Cepat (10 halaman), Panduan Pengguna (20 halaman)

Halaman Cetak

10. Flight

Safe to Fly (GPS)

Before taking off, make sure the aircraft

status bar in the DJI Pilot app shows "Safe

to Fly (GPS)". Otherwise, the aircraft cannot

hover in place and record the Home Point.

Manual Take - off & Landing：

●

Start the motors by pulling both control sticks to the bottom inside corners.

Release the sticks once the motors start. Slowly push the left (throttle) stick

up to take off. Once in the air, toggle the Transformation Switch up to raise

the landing gear.

Start / Stop the motors

Gently pull the left (throttle) stick down to lower the aircraft

until it touches the ground. Pull both sticks to the bottom

inside corners to stop the motors.

After flight, change the aircraft back into Travel Mode. Do not

attempt this at the beach, over grass, or over monochromatic

carpet. Then place the aircraft on a flat surface and remove

the gimbal and camera for transport.

It is highly recommended that you only take off when the Aircraft Status bar is green.

●

The aircraft cannot take off if the Critical Low Battery Warning is active.

●

The Intelligent Flight Battery must warm-up if the outside temperature is low. A

●

warning will display in the DJI Pilot app.

Rotating propellers can be dangerous. Do not start the motors when there are

●

people nearby and always fly in a wide open area.

Never stop the motors during flight. Power off the aircraft prior to switching off the

●

remote controller after landing.

Appendix

Aircraft

Status Indicator Description

Slowly: Safe to fly,GPS working

Double: Vision Positioning

System working, no GPS

Slowly: P-ATTI or ATTI

Quickly: Not connected

to remote controller

Slowly: Low battery level warning

Quickly: Critical low battery level warning

Solid: Critical error

Blinking Alternately:

Compass calibration required

Auto Taking - Off & Landing:

●

( In the Camera screen of the DJI Pilot app )

Tap

and confirm your selection. The aircraft will automatically take off, retract

its landing gear, and hover at 1.5 meters after you tap and confirm Auto Take-off.

Tap

and confirm your selection. The landing gear will lower and the aircraft

will automatically land.

Left stick / Up (Slowly)

Toggle the Transformation

Left stick / Down (Slowly)

Remote Controller

Status LED

Remote controller is functioning normally

but is not connected to the aircraft.

Remote controller is functioning normally

and is connected to the aircraft.

Remote controller is in Slave Mode

and not connected to the aircraft.

Remote controller is in Slave Mode

and is connected to the aircraft.

B-B-B... Aircraft low battery warning

or remote controller error.

B—B—... Remote controller has been

idle for 5 minutes.

Learn more information from:

www.dji.com/product/inspire-1

Return to Home

●

RTH Button

1. Press and hold the return home

button until the LED surrounding

the button is blinking white, and the

return home procedure is in

process. Press once to stop the

Switch up

procedure.

2. The DJI Pilot app notifies users to

take action when the battery level

falls to a specified threshold. This

warning threshold can be set

within the DJI Pilot app. The

aircraft will land immediately when

it reaches Critical Low Battery

Level Warning.

3. Failsafe: The Inspire 1 will enter

RTH mode if remote controller

signal is lost.

Using the Camera

Adjust the camera parameters using the

●

Camera Settings Dial on the remote

controller or through the DJI Pilot app.

Press the Shutter Button/Video Record

Button to capture photos or record

videos.

Adjust the tilt of the gimbal using the

●

Gimbal Dial.

Download photos and video from the SD

●

card to your mobile device through the

DJI Pilot app. You may also use a SD

card reader to export files to your PC.

The App's

RTH Button

While returning home, its

●

altitude can be adjusted by the

user to avoid obstructions.