dji Inspire 1 Краткое руководство по эксплуатации - Страница 9

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Квадрокоптеры dji Inspire 1. dji Inspire 1 11 страниц.
Также для dji Inspire 1: Краткое руководство по эксплуатации (10 страниц), Руководство пользователя (20 страниц)

dji Inspire 1 Краткое руководство по эксплуатации
10. Flight
Safe to Fly (GPS)
Before taking off, make sure the aircraft
status bar in the DJI Pilot app shows "Safe
to Fly (GPS)". Otherwise, the aircraft cannot
hover in place and record the Home Point.
Manual Take - off & Landing:
Start the motors by pulling both control sticks to the bottom inside corners.
Release the sticks once the motors start. Slowly push the left (throttle) stick
up to take off. Once in the air, toggle the Transformation Switch up to raise
the landing gear.
Start / Stop the motors
Gently pull the left (throttle) stick down to lower the aircraft
until it touches the ground. Pull both sticks to the bottom
inside corners to stop the motors.
After flight, change the aircraft back into Travel Mode. Do not
attempt this at the beach, over grass, or over monochromatic
carpet. Then place the aircraft on a flat surface and remove
the gimbal and camera for transport.
It is highly recommended that you only take off when the Aircraft Status bar is green.
The aircraft cannot take off if the Critical Low Battery Warning is active.
The Intelligent Flight Battery must warm-up if the outside temperature is low. A
warning will display in the DJI Pilot app.
Rotating propellers can be dangerous. Do not start the motors when there are
people nearby and always fly in a wide open area.
Never stop the motors during flight. Power off the aircraft prior to switching off the
remote controller after landing.
Appendix
Aircraft
Status Indicator Description
Slowly: Safe to fly,GPS working
X
2
Double: Vision Positioning
System working, no GPS
Slowly: P-ATTI or ATTI
Quickly: Not connected
to remote controller
Slowly: Low battery level warning
Quickly: Critical low battery level warning
Solid: Critical error
Blinking Alternately:
Compass calibration required
Auto Taking - Off & Landing:
( In the Camera screen of the DJI Pilot app )
Tap
and confirm your selection. The aircraft will automatically take off, retract
its landing gear, and hover at 1.5 meters after you tap and confirm Auto Take-off.
Tap
and confirm your selection. The landing gear will lower and the aircraft
will automatically land.
Left stick / Up (Slowly)
Toggle the Transformation
Left stick / Down (Slowly)
Remote Controller
Status LED
Remote controller is functioning normally
but is not connected to the aircraft.
Remote controller is functioning normally
and is connected to the aircraft.
Remote controller is in Slave Mode
and not connected to the aircraft.
Remote controller is in Slave Mode
and is connected to the aircraft.
B-B-B... Aircraft low battery warning
or remote controller error.
B—B—... Remote controller has been
idle for 5 minutes.
Learn more information from:
www.dji.com/product/inspire-1
Return to Home
RTH Button
1. Press and hold the return home
button until the LED surrounding
the button is blinking white, and the
return home procedure is in
process. Press once to stop the
Switch up
procedure.
2. The DJI Pilot app notifies users to
take action when the battery level
falls to a specified threshold. This
warning threshold can be set
within the DJI Pilot app. The
aircraft will land immediately when
it reaches Critical Low Battery
Level Warning.
3. Failsafe: The Inspire 1 will enter
RTH mode if remote controller
signal is lost.
Using the Camera
Adjust the camera parameters using the
Camera Settings Dial on the remote
controller or through the DJI Pilot app.
Press the Shutter Button/Video Record
Button to capture photos or record
videos.
Adjust the tilt of the gimbal using the
Gimbal Dial.
Download photos and video from the SD
card to your mobile device through the
DJI Pilot app. You may also use a SD
card reader to export files to your PC.
The App's
RTH Button
While returning home, its
altitude can be adjusted by the
user to avoid obstructions.
©
2014 DJI. All Rights Reserved
Designed by DJI. Printed in China.