Artila Matrix-512 Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk PC Industri Artila Matrix-512. Artila Matrix-512 17 halaman. Linux arm9 industry box computer
3. Pin Assignment and Definition
3.1 Reset Button
Press the "Reset" button to activate the hardware reset. You should only use this function if the
software does not function properly.
3.2 Power LED
The Power LED will show solid green if power is properly applied.
3.3 Ready LED
The Ready LED will show solid green if Matrix-512 complete system boot up. If Ready LED is off
during system boot up, please check if power input is correct. Turn off the power and restart
Matrix-512 again. If Ready LED is still off, please contact the manufacture for technical support.
3.4 Link / Act LED
When Ethernet port are connected to the network, Link/Act will show solid green and if there is traffic is
the Ethernet port, this LED will flash.
3.5 Serial Port LED
These four dual color LEDs indicate the data traffic at the serial ports. When RxD line is high then
Green light is ON and when TxD line is high, Yellow light is ON.
3.6 Ethernet Port
3.7 Serial Port
The four serial ports are 3-in-one RS-232/422/485 ports and the interface is configured in by software.
Please refer to example program to configure the serial or use "setuart" utility to configure serial port
setting. RS-485 hardware supports data direction control. Therefore it is software compatible with a
RS-232 interface.
Pin No.
Signal
1
ETx+
2
ETx-
3
ERx+
6
ERx-
‧3‧
Matrix-512 User Guide