Artillian 1UTVRK Panduan Instalasi & Pemilik - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Instalasi & Pemilik untuk Rak dan Dudukan Artillian 1UTVRK. Artillian 1UTVRK 8 halaman. Utv bed mounted tool rack

Halaman Cetak

WARNING

It is the user's responsibility to ensure that installation of this product

does not affect the functionality of the vehicle ROPS, tires, or any other

safety feature of the vehicle. Failure to do so may result in injury or

death. Due to the many variations between UTV models, the UTV

Mounted Tool Bar or Tool Rack or some of its quick removal accessories

may interfere with dump bed operation, fender flares, or tires. If

necessary, the quick-release Cam Lever Latches on the ROPS Mounted

Tool Bar accessories allow a given accessory to be quickly removed and

relocated to a non-interfering location.

Artillian strives to continuously improve our products. As such, the actual

product may vary from the images shown throughout this manual.

INSTALLATION

Park the vehicle on a flat, level surface.

1. See fig. 1. Install (4) Tool Bar mounting brackets using the

installation instructions included with the 1UTVTB kit.

a. Note: It will help to utilize the included tool bar (ref.: 42" long

tube) to determine the optimal locations for the mounting

brackets on your vehicle bed, but do not fasten the tube to

the mounting brackets at this time.

2. See fig. 2. With an assistant, install a UTV Tool Rack Vertical Tube

(ref.: 32" long tube) onto the inboard side of the mounting bracket,

as shown. Ensure that the two threaded inserts on the opposite

side of the tube are at the top.

a. Using the tube clamp and hardware provided in the 1UTVTB

kit, fasten the vertical tube and the horizontal tool bar to the

mounting bracket

Hardware: 5/16-18 X 1" LG. Flange Head Cap Screws (FHCS)

3. See fig. 3. Repeat step 2 for the second vertical tube.

4. See fig. 4. Repeat steps 2 - 3 for the other side of the UTV bed.

5. See fig. 5. Install the cross bar mounting brackets to the top

inboard side of each vertical tube in the orientations shown.

a. Image 5a is a close-up view of the corner "a" mounting

bracket installed on the inboard side of the vertical tube.

(Rotated for clarity)

Hardware: 5/16-18 X ¾" LG. FHCS

Corner "a"

Fig. 5

KIT INSTALLATION

Fig. 5a

UTV Bed

Tool Bar

Mounting

Bracket

Fig. 1

Tool Bar

Fig. 2

Fig. 3

Fig. 4

3 of 8

Vertical

Tube