Artillian 1RMTBXS Panduan Instalasi & Pemilik - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi & Pemilik untuk Penyimpanan Alat Artillian 1RMTBXS. Artillian 1RMTBXS 3 halaman. Rops mounted toolbox, small, 20"x10"x11"

Halaman Cetak

FEATURES AND OPERATION

ATTACH TO MOUNTING BAR:

Figure 1 shows a toolbox installed onto an Artillian

ROPS Mounted Tool Bar.

2. To install the toolbox, rotate both cam levers UP,

then place onto the Tool Bar. See fig. 2.

Note: if the Cam Lever Latches do not sit flush on the Tool Bar, one

of the clamp plates may not have been fully open. Simply remove the

toolbox, rotate the cam levers up and tilt the toolbox away from you to

ensure the clamp plates are fully open, then reinstall on the Tool Bar.

3. To secure the toolbox to the Tool Bar, rotate both

cam levers DOWN until they cam over. See fig. 3.

NOTE: For additional security, the toolbox can be locked to the Tool

Bar by inserting a padlock through the holes in the mounting bracket

where shown in fig. 3.

4. To remove the toolbox from the Tool Bar, rotate

both cam levers UP, then lift the toolbox.

FEATURES AND OPERATION

1. For optimal functionality, the cam lever latches are

factory assembled with some friction between the

cam lever and the housing. This ensures the cam

lever doesn't accidentally flip closed while the user

attempts to install it on the bar. If the cam levers

loosen up over time, simply tighten the nut and bolt

that secure the lever to the housing until the

desired resistance on the cam lever has been

achieved.

Fig. 1 (attaching a tool box)

rotate both cam levers up

to install the toolbox

Fig. 2 (cam lever in the open position)

padlock holes

rotate both cam levers down

to secure the toolbox

Fig. 3 (cam lever in the closed position)

2 of 3