Artillian 1RMTBXS Kurulum ve Kullanım Kılavuzu - Sayfa 2
Alet Deposu Artillian 1RMTBXS için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Artillian 1RMTBXS 3 sayfaları. Rops mounted toolbox, small, 20"x10"x11"
FEATURES AND OPERATION
ATTACH TO MOUNTING BAR:
1.
Figure 1 shows a toolbox installed onto an Artillian
ROPS Mounted Tool Bar.
2. To install the toolbox, rotate both cam levers UP,
then place onto the Tool Bar. See fig. 2.
Note: if the Cam Lever Latches do not sit flush on the Tool Bar, one
of the clamp plates may not have been fully open. Simply remove the
toolbox, rotate the cam levers up and tilt the toolbox away from you to
ensure the clamp plates are fully open, then reinstall on the Tool Bar.
3. To secure the toolbox to the Tool Bar, rotate both
cam levers DOWN until they cam over. See fig. 3.
NOTE: For additional security, the toolbox can be locked to the Tool
Bar by inserting a padlock through the holes in the mounting bracket
where shown in fig. 3.
4. To remove the toolbox from the Tool Bar, rotate
both cam levers UP, then lift the toolbox.
FEATURES AND OPERATION
1. For optimal functionality, the cam lever latches are
factory assembled with some friction between the
cam lever and the housing. This ensures the cam
lever doesn't accidentally flip closed while the user
attempts to install it on the bar. If the cam levers
loosen up over time, simply tighten the nut and bolt
that secure the lever to the housing until the
desired resistance on the cam lever has been
achieved.
Fig. 1 (attaching a tool box)
rotate both cam levers up
to install the toolbox
Fig. 2 (cam lever in the open position)
padlock holes
rotate both cam levers down
to secure the toolbox
Fig. 3 (cam lever in the closed position)
2 of 3