Custom Dynamics Smart Triple Play GEN-SMART-TPU-UNV Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Aksesori Mobil Custom Dynamics Smart Triple Play GEN-SMART-TPU-UNV. Custom Dynamics Smart Triple Play GEN-SMART-TPU-UNV 5 halaman. Run brake turn controller with built in strobe/flasher

Halaman Cetak
SMART TRIPLE PLAY® Run Brake Turn Controller with
Built in Strobe/Flasher (Patent Pending)
5. Initial Setup and Operation: Locate the two switches and rotary dial. Be sure the rotary
dial is set to position 0. Note there is a screw diver slot to make the dial turn easer, this
is not the pointer, there is small arrow on the dial , this is the pointer that should now be
at position 0. Be sure Switch 1 and Switch 2 are both in the ON position.
On On
2
1
Rotary
Off Off
6. Turn the ignition key on and check operation as follows:
Running Lights: Turn Signals and Taillight are now illuminated dimly.
•
Apply Right Turn Signal and check operation of right turn signal, should flash off to
•
bright. Disable turn.
Apply Left Turn Signal and check operation of left run signal, should flash off to bright.
•
Disable turn.
Apply Brake Light. Check to see that all 3 lights flash 4 times then remain bright.
•
Apply Left Turn Signal then Apply Brake, Check to see that Only Center Light
•
Flashes 4 times then remains bright.
Installation Instructions