Custom Dynamics Smart Triple Play GEN-SMART-TPU-UNV Installation Instructions - Page 4

Browse online or download pdf Installation Instructions for Automobile Accessories Custom Dynamics Smart Triple Play GEN-SMART-TPU-UNV. Custom Dynamics Smart Triple Play GEN-SMART-TPU-UNV 5 pages. Run brake turn controller with built in strobe/flasher

Print Page

SMART TRIPLE PLAY® Run Brake Turn Controller with

Built in Strobe/Flasher (Patent Pending)

5. Initial Setup and Operation: Locate the two switches and rotary dial. Be sure the rotary

dial is set to position 0. Note there is a screw diver slot to make the dial turn easer, this

is not the pointer, there is small arrow on the dial , this is the pointer that should now be

at position 0. Be sure Switch 1 and Switch 2 are both in the ON position.

On On

Rotary

Off Off

6. Turn the ignition key on and check operation as follows:

Running Lights: Turn Signals and Taillight are now illuminated dimly.

•

Apply Right Turn Signal and check operation of right turn signal, should flash off to

•

bright. Disable turn.

Apply Left Turn Signal and check operation of left run signal, should flash off to bright.

•

Disable turn.

Apply Brake Light. Check to see that all 3 lights flash 4 times then remain bright.

•

Apply Left Turn Signal then Apply Brake, Check to see that Only Center Light

•

Flashes 4 times then remains bright.

Installation Instructions