Artison Sketch LCR DualMono MK 2 Panduan Referensi Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Referensi Cepat untuk Pembicara Artison Sketch LCR DualMono MK 2. Artison Sketch LCR DualMono MK 2 4 halaman.
Juga untuk Artison Sketch LCR DualMono MK 2: Panduan Instalasi (16 halaman), Panduan Referensi Cepat (4 halaman), Panduan Instalasi (4 halaman)
Halaman Cetak
Stage Tweeter (On/Off Switch)
The Stage Tweeter on the rear of the speaker enclosure widens the left and right channel separation by directing out-of-phase
high frequencies (6 kHz and higher) against the adjacent wall. The installation will determine whether the stage tweeter switch
should be ON/UP or OFF/DOWN. Set the stage tweeter before mounting speaker into the wall mount bracket.
OFF
Installations where the speakers and TV are flush mounted into recessed cabinetry
or when mounted flush to the wall using the in-wall mount kit (LCRDM-IW-KIT).
ON
All other installations.
Install Main LCR Brackets
Each LCRDM MK2 speaker includes a mounting bracket. These brackets
are mounted to each speaker for shipment. Follow instructions below to
mount to an existing wall or similar.
IMPORTANT! DO NOT place speakers face down as this can perma-
nently damage the individual drivers.
1. Remove thumbscrews from top and bottom of speaker and remove
mounting bracket.
2. Position the bracket on the wall (either left or right of TV) and with a
level, ensure bracket is plumb.
3. With a pencil, mark the two mounting slots. See image to the right.
4. If there is a sub wall to screw to, secure the bracket using #6 self
tapping screws (not included). If there is no sub wall, sturdy drywall
anchors that can support at least 20 lbs (9.07 kg) can be used.
5. Repeat steps 1 - 4 and mount the second speaker bracket to the
opposite side of TV.
NOTE: The LCR brackets along with the Universal Mounting Brackets
(UMB-xx) can also be used to mount the LCR speakers directly to the
side of a TV. For installation instructions, refer to the documentation
included with the Universal Mounting Brackets.
Mount Speakers
With the speaker wired and Stage Tweeter ON/OFF switch set, mount the speaker enclosure into the wall mount brackets in-
stalled in the Install Main LCR Brackets section above.
1. Slide the right channel speaker enclosure into the wall mount bracket with the stage tweeter facing away from the TV.
2. Secure the speaker to the bracket using the thumbscrews removed in the previous section.
3. Repeat steps 1 and 2 and mount the left channel speaker into the wall mount bracket. When complete, the installation will
look like below.
P-LCRDM-MK2 | 009-1626-00 | 181113
Copyright 2018 Savant Systems, LLC
Speakers are secured to
brackets using thumbscrews
Flat Panel TV
Mounted to Wall
3
of
4
Secure bracket to wall
using #6 x 1 ½ inch screws
and heavy duty wall anchors
2231 Meridian Blvd #1, Minden Nevada 89423
www.savant.com/artisonspeakers
| 775.783.4770