- ページ 3

スピーカー Artison Sketch LCR DualMono MK 2のPDF クイック・リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Artison Sketch LCR DualMono MK 2 4 ページ。
Artison Sketch LCR DualMono MK 2 にも：インストレーション・マニュアル (16 ページ), クイック・リファレンス・マニュアル (4 ページ), インストレーション・マニュアル (4 ページ)

Stage Tweeter (On/Off Switch)

The Stage Tweeter on the rear of the speaker enclosure widens the left and right channel separation by directing out-of-phase

high frequencies (6 kHz and higher) against the adjacent wall. The installation will determine whether the stage tweeter switch

should be ON/UP or OFF/DOWN. Set the stage tweeter before mounting speaker into the wall mount bracket.

OFF

Installations where the speakers and TV are flush mounted into recessed cabinetry

or when mounted flush to the wall using the in-wall mount kit (LCRDM-IW-KIT).

All other installations.

Install Main LCR Brackets

Each LCRDM MK2 speaker includes a mounting bracket. These brackets

are mounted to each speaker for shipment. Follow instructions below to

mount to an existing wall or similar.

IMPORTANT! DO NOT place speakers face down as this can perma-

nently damage the individual drivers.

1. Remove thumbscrews from top and bottom of speaker and remove

mounting bracket.

2. Position the bracket on the wall (either left or right of TV) and with a

level, ensure bracket is plumb.

3. With a pencil, mark the two mounting slots. See image to the right.

4. If there is a sub wall to screw to, secure the bracket using #6 self

tapping screws (not included). If there is no sub wall, sturdy drywall

anchors that can support at least 20 lbs (9.07 kg) can be used.

5. Repeat steps 1 - 4 and mount the second speaker bracket to the

opposite side of TV.

NOTE: The LCR brackets along with the Universal Mounting Brackets

(UMB-xx) can also be used to mount the LCR speakers directly to the

side of a TV. For installation instructions, refer to the documentation

included with the Universal Mounting Brackets.

Mount Speakers

With the speaker wired and Stage Tweeter ON/OFF switch set, mount the speaker enclosure into the wall mount brackets in-

stalled in the Install Main LCR Brackets section above.

1. Slide the right channel speaker enclosure into the wall mount bracket with the stage tweeter facing away from the TV.

2. Secure the speaker to the bracket using the thumbscrews removed in the previous section.

3. Repeat steps 1 and 2 and mount the left channel speaker into the wall mount bracket. When complete, the installation will

look like below.

P-LCRDM-MK2 | 009-1626-00 | 181113

Speakers are secured to

brackets using thumbscrews

Flat Panel TV

Mounted to Wall

Secure bracket to wall

using #6 x 1 ½ inch screws

and heavy duty wall anchors

2231 Meridian Blvd #1, Minden Nevada 89423

www.savant.com/artisonspeakers

| 775.783.4770