3M 710 Petunjuk Manual - Halaman 10

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Proyektor 3M 710. 3M 710 20 halaman. Splicing rig
Juga untuk 3M 710: Brosur & Spesifikasi (4 halaman), Spesifikasi (4 halaman)

Halaman Cetak

4.5 Spread the conductors around the "T" bar without

disturbing them in the module body. Pull the "T" bar

up above the module body. Push the "T" bar forward

and down until contact is made with the conductors.

Pull the handle down to the stop, seating and cutting

the conductors in the module body. Remove the

excess conductors. Engage the handle into the

retaining clip, pull the "T" bar up, and place into the

open position.

4.6 Place a cap on the module body. Use finger pressure

to push down the cap to pre-engage it to the module

body. The cap latches should face the color code

guide. Pull the "T" bar up above the cap. Push the

"T" bar forward and down until contact is made with

the cap. Pull the handle down to the stop, seating the

cap into the module body. Engage the handle into

the retaining clip, pull the "T" bar up, and place into

the open position. Push in the "L" clip to release the

module and remove from the splicing rig. The 25-

pair half-tap splice module is complete.

5.0 Bridge Splicing with 3M

Module Support

5.1 Place a red bridge module support into the splicing

rig with the word FRONT facing the color code

guide. Push the "L" clip in to secure the bridge

module support.

5.2 Place a bridge module into the bridge module

support with the cathedral windows facing the color

code guide.

710 25-pair Modules using the Red Bridge

™

78-815-304--E