ALUZ A8-ZIZA-STN Manual - Halaman 8
Jelajahi secara online atau unduh pdf Manual untuk Peralatan Pencahayaan ALUZ A8-ZIZA-STN. ALUZ A8-ZIZA-STN 12 halaman. Led tape
Halaman Cetak
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment of
mounting clips. Mark location where each mounting clip will be installed
along reference line.
2
Mark location where mounting clips will be installed.
Note: The number of required mounting clips differs for dry and wet location
products. Verify number of mounting clips is appropriate for installation
environment before installing. Do not install luminaires with inadequate
number of mounting clips.
3
Lay mounting clips along reference line and pre-drill using an appropriate
drill bit for surface and screw size. Recommendation: 8/32 x 1" screw.
Note: Allow 0.25" clearance for lateral expansion of assembled mounting
clips. Only install mounting clips on flat, even surfaces.
4
Screw mounting clips to surface, then snap extrusions into mounting clips.
Note: Ensure extrusions are aligned. Misalignment will prevent lens from
snapping in.
MC
5
After all extrusions have been securely mounted, remove adhesive backing
from lightstrip and adhere in place along extrusion channel, ensuring
lightstrip is secure inside extrusion.
Note: Refer to Application Guidelines to ensure correct installation.
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A8 Series | LED Tape
ZIZA Standard
(A8-ZIZA-STN)
Install lightstrip into extrusions
Remove adhesive backing
866.ALUZ.LTG | 714.535.7900
6
If applicable, connect disconnects between luminaires or solder connectors
using the steps from Application Guidelines.
7
Install lens into extrusion, overlapping where two extrusions meet. Plan
your cuts so that the lens will always overlap where two extrusions meet.
Overlapping lenses helps keep extrusions aligned and prevents light leaks.
Two extrusions meet
8
Perform a continuity test before connecting luminaire to power source.
Page 8 of 12
Mounting Fixture
(Dry Location Mounting Clips)
Lens overlapping
Installation Instructions
4 / 11 / 2022 / Rev 1