ALUZ A8-ZIZA-STN Manuel - Sayfa 8

Aydınlatma Ekipmanları ALUZ A8-ZIZA-STN için çevrimiçi göz atın veya pdf Manuel indirin. ALUZ A8-ZIZA-STN 12 sayfaları. Led tape

Measure area where luminaire will be installed. Use a laser line to create

a reference line along installation area, ensuring consistent alignment of

mounting clips. Mark location where each mounting clip will be installed

along reference line.

Mark location where mounting clips will be installed.

Note: The number of required mounting clips differs for dry and wet location

products. Verify number of mounting clips is appropriate for installation

environment before installing. Do not install luminaires with inadequate

number of mounting clips.

Lay mounting clips along reference line and pre-drill using an appropriate

drill bit for surface and screw size. Recommendation: 8/32 x 1" screw.

Note: Allow 0.25" clearance for lateral expansion of assembled mounting

clips. Only install mounting clips on flat, even surfaces.

Screw mounting clips to surface, then snap extrusions into mounting clips.

Note: Ensure extrusions are aligned. Misalignment will prevent lens from

snapping in.

After all extrusions have been securely mounted, remove adhesive backing

from lightstrip and adhere in place along extrusion channel, ensuring

lightstrip is secure inside extrusion.

Note: Refer to Application Guidelines to ensure correct installation.

1170 N Red Gum St, Anaheim, CA 92806

aluz.lighting

A8 Series | LED Tape

ZIZA Standard

(A8-ZIZA-STN)

Install lightstrip into extrusions

Remove adhesive backing

866.ALUZ.LTG | 714.535.7900

If applicable, connect disconnects between luminaires or solder connectors

using the steps from Application Guidelines.

Install lens into extrusion, overlapping where two extrusions meet. Plan

your cuts so that the lens will always overlap where two extrusions meet.

Overlapping lenses helps keep extrusions aligned and prevents light leaks.

Two extrusions meet

Perform a continuity test before connecting luminaire to power source.

Page 8 of 12

Mounting Fixture

(Dry Location Mounting Clips)

Lens overlapping

Installation Instructions

4 / 11 / 2022 / Rev 1