Doberman SE-0101C Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Sistem Keamanan Doberman SE-0101C. Doberman SE-0101C 12 halaman. Door and window defender w/chime

Halaman Cetak

SE-0119 WIRELESS DOOR ALARM W/REMOTE

Magnetically Triggered Door Alarm and Remote Control

PACKAGE INCLUDES:

Main Unit ... 1PC

Magnetic Sensor ... 1PC

Remote Control ... 1PC

INSTALLATION:

Simply peel and stick the alarm to the door or any other place you wish to protect.

For best performance, keep the distance between the Main Unit and Magnetic Sensor

no wider than half an inch.

The Magnetic Sensor can be installed on either side of the Main Unit. (see drawing

below)

BATTERY INSTALLATION/ REPLACEMENT:

Main Unit:

Set the switch to OFF and slide down the battery cover.

Follow the polarity instructions to insert 3 AAA Alkaline batteries (not included).

Put the battery cover back on.

Remote Control:

Unscrew the back cover to insert or replace 1 fresh CR2032 battery. Follow the

polarity instructions.

Press any button on the remote Control. The red LED will light if the battery is installed

correctly.

OPERATION:

Remote Mode:

Make sure the Magnetic Sensors are aligned and batteries are installed correctly.

After installing the batteries, slide the switch to

Slide down the battery cover and press the small button above the battery

compartment once. A beep will sound, and the red LED will flash for 5 seconds.

While the LED is still flashing, press any button on the Remote Control and you'll

hear 2 Beeps. This indicates the code has been learned successfully.

After the code has been learned, wait 5 seconds, then press and hold the ON button

on the Remote Control. A Beep will sound, and the Main Unit will be armed within

three seconds. The red LED will flash three times indicating is has been armed.

Press the OFF button on the Remote Control, a Beep will sound, accompanied by a

flashing red LED. The device is now disarmed.

Under ARM status, once the door is opened, the alarm will go off continuously for 30

seconds.

Turn off the alarm by pressing the OFF button on the Remote Control or slide the

switch to OFF on the Main Unit.

Manual Mode:

Make sure the Magnetic Sensors are aligned and that the batteries are installed

correctly.

Slide the switch to , and the Main Unit will be armed in three seconds and the red

LED will flash three times.

Once the door is opened, the alarm will go off continuously for 30 seconds.

Turn off the alarm by sliding the switch to OFF.

, and the red LED will flash once.