Doberman SE-0101C Руководство - Страница 5
Просмотреть онлайн или скачать pdf Руководство для Система безопасности Doberman SE-0101C. Doberman SE-0101C 12 страниц. Door and window defender w/chime
Печатать страницу
SE-0119 WIRELESS DOOR ALARM W/REMOTE
Magnetically Triggered Door Alarm and Remote Control
PACKAGE INCLUDES:
Main Unit ... 1PC
Magnetic Sensor ... 1PC
Remote Control ... 1PC
INSTALLATION:
Simply peel and stick the alarm to the door or any other place you wish to protect.
For best performance, keep the distance between the Main Unit and Magnetic Sensor
no wider than half an inch.
The Magnetic Sensor can be installed on either side of the Main Unit. (see drawing
below)
BATTERY INSTALLATION/ REPLACEMENT:
Main Unit:
Set the switch to OFF and slide down the battery cover.
Follow the polarity instructions to insert 3 AAA Alkaline batteries (not included).
Put the battery cover back on.
Remote Control:
Unscrew the back cover to insert or replace 1 fresh CR2032 battery. Follow the
polarity instructions.
Press any button on the remote Control. The red LED will light if the battery is installed
correctly.
OPERATION:
Remote Mode:
Make sure the Magnetic Sensors are aligned and batteries are installed correctly.
After installing the batteries, slide the switch to
Slide down the battery cover and press the small button above the battery
compartment once. A beep will sound, and the red LED will flash for 5 seconds.
While the LED is still flashing, press any button on the Remote Control and you'll
hear 2 Beeps. This indicates the code has been learned successfully.
After the code has been learned, wait 5 seconds, then press and hold the ON button
on the Remote Control. A Beep will sound, and the Main Unit will be armed within
three seconds. The red LED will flash three times indicating is has been armed.
Press the OFF button on the Remote Control, a Beep will sound, accompanied by a
flashing red LED. The device is now disarmed.
Under ARM status, once the door is opened, the alarm will go off continuously for 30
seconds.
Turn off the alarm by pressing the OFF button on the Remote Control or slide the
switch to OFF on the Main Unit.
Manual Mode:
Make sure the Magnetic Sensors are aligned and that the batteries are installed
correctly.
Slide the switch to , and the Main Unit will be armed in three seconds and the red
LED will flash three times.
Once the door is opened, the alarm will go off continuously for 30 seconds.
Turn off the alarm by sliding the switch to OFF.
, and the red LED will flash once.
1