Doiting ESP-M1 Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Router Nirkabel Doiting ESP-M1. Doiting ESP-M1 19 halaman.

DOITING

The module is limited to installation in mobile application; A separate approval is required for all other

operating configurations, including portable configurations with respect to Part 2.1093 and difference

antenna configurations.

We use the bottom plate to assist the test, but the bottom plate is not needed when the module

is installed, and it can be directly installed on the product.

FCC Part 15B Compliance of End Device

The OEM integrator is responsible for ensuring that the host product which is installed and operating

with the module is in compliant with Part 15B unintentional Radiator requirements, please note that For a

Class B digital device or peripheral, the instructions furnished the user manual of the end-user product

shall include the following or similar statement, placed in a prominent location in the text of the manual:

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

— Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

—Consult the dealer or an experienced radio/TV technician for help.

List of applicable FCC rules：FCC Part15 Subpart C, Section 15.247

Information on test modes and additional testing requirements

To investigate the maximum EMI emission characteristics generates from EUT, the test system was pre-

scanning tested base on the consideration of following EUT operation mode or test configuration mode

which possible have effect on EMI emission level. Each of these EUT operation mode(s) or test

configuration mode(s) mentioned above was evaluated respectively.

RADIATED EMISSION TEST (BELOW 1GHz):

Pre-Scan has been conducted to determine the worst-case mode from all possible combinations between

available modulations, data rates, XYZ axis and antenna ports (if EUT with antenna diversity

ESP-M1/M2 User Mannual

Page 14