Doiting ESP-M1 Panduan Pengguna - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Router Nirkabel Doiting ESP-M1. Doiting ESP-M1 19 halaman.

Halaman Cetak

DOITING

ESP-M1/M2 User Mannual

architecture).

For the test results, only the worst case was shown in test report.

RADIATED EMISSION TEST (ABOVE 1GHz):

Pre-Scan has been conducted to determine the worst-case mode from all possible combinations between

available modulations, data rates, XYZ axis and antenna ports (if EUT with antenna diversity

architecture).

Additional testing Part15SubpartB disclaimer

The grantee should include a statement that the modular transmitter is only FCC authorized forthe

specific rule parts (i.e.，FCC transmitter rules )listedonthegrant， and that the host productmanufacturer

is responsible for compliance to any other FCC rules that apply to the host notcovered by the modular

transmitter grant of certification .If the grantee markets their product asbeing Part

15SubpartBcompliant( when it also contains unintentional - radiator digital circuit y)， then the grantee

shall provide a notice stating that the final host product still requires Part 15 Subpart B compliance testing

with the modular transmitter installed .

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 20cm between the radiator &

your body.

FCC INFORMATION (additional)

OEM INTEGRATION INSTRUCTIONS:

This device is intended only for OEM integrators under the following conditions: The module must be

installed in the host equipment such that 20 cm is maintained between the antenna and users, and the

transmitter module may not be co-located with any other transmitter or antenna. The module shall be only

used with the internal antenna(s) that has been originally tested and certified with this module. As long as

3 conditions above are met, further transmitter test will not be required. However, the OEM integrator is

still responsible for testing their end-product for any additional compliance requirements required with

this module installed (for example, digital device emissions, PC peripheral requirements, etc.).

Validity of using the module certification:

In the event that these conditions cannot be met (for example certain laptop configurations or co-location

with another transmitter), then the FCC authorization for this module in combination with the host

equipment is no longer considered valid and the FCC ID of the module cannot be used on the final

product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product

(including the transmitter) and obtaining a separate FCC authorization.

Module label:

FCC ID: 2A2P9-ESP-M2

The final end product must be labeled in a visible area with the following: "Contains FCC ID:2A2P9-

ESP-M2 ". Information that must be placed in the end user manual:

The OEM integrator has to be aware not to provide information to the end user regarding how to install or

remove this RF module in the user's manual of the end product which integrates this module. The end

user manual shall include all required regulatory information/warning as show in this manual.

The module not applicable Limited module procedures. The module is a Single module and complies

with the requirement of FCCPart15.247

The module has its own antenna ，anddoesn'tneedahost's printed board microstriptrace antenna etc, Not

applicable Trace antenna designs

Page 15