ASGCO CHEVRON Panduan Petunjuk Pemasangan, Pengoperasian & Pemeliharaan - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan, Pengoperasian & Pemeliharaan untuk Pembersih Perhiasan Ultrasonik ASGCO CHEVRON. ASGCO CHEVRON 12 halaman. Belt cleaners

Halaman Cetak
Chevron
Installation
ASGCO Mfg., Inc.
When all of the bolt heads have been welded, the Chevron installation can
begin. Start with the last shaft installation and work forward toward the
head pulley.
1. Install an Chevron mounting bracket on each of the bolts. To do this,
loosen the nut, slide the bracket into position, then snug up the nut by
hand tightening. Be sure that the top of the bracket (the part with two
notches) is facing up as shown.
2. Flats must be filed at the set screw locations on the end of the Chevron
shaft. To do this, position the shaft inside the pillow block and remove the
two set screws using an Allen wrench. Insert a punch into the set screw
holes and mark their positions on the shaft. Replace the set screws and
remove the shaft from the pillow block, and file the flats as indicated by
the marks.
Chevron Shaft
Pillow
Block
Chevron
Mounting
Bracket
3. Position one end of the shaft, then the other, through the rectangular
cutouts in the chute wall.
4. Slide the pillow blocks over the shaft with the flats facing the set screws.
Tighten the set screws with an Allen wrench.
5. Fasten both pillow blocks to the bracket with3/8 " x 1 1/2" long bolts and
hardware (flatwasher, locking washer and nut).
Head Pulley
Chute Walls
Chevron Mounting Brackets
Chute Wall
8
Conveyor Belt
CHEVRON