ASGCO CHEVRON Installation, Operation & Maintenance Instructions Manual - Page 10

Browse online or download pdf Installation, Operation & Maintenance Instructions Manual for Ultrasonic Jewelry Cleaner ASGCO CHEVRON. ASGCO CHEVRON 12 pages. Belt cleaners

Print Page

Chevron

Installation

ASGCO Mfg., Inc.

When all of the bolt heads have been welded, the Chevron installation can

begin. Start with the last shaft installation and work forward toward the

head pulley.

1. Install an Chevron mounting bracket on each of the bolts. To do this,

loosen the nut, slide the bracket into position, then snug up the nut by

hand tightening. Be sure that the top of the bracket (the part with two

notches) is facing up as shown.

2. Flats must be filed at the set screw locations on the end of the Chevron

shaft. To do this, position the shaft inside the pillow block and remove the

two set screws using an Allen wrench. Insert a punch into the set screw

holes and mark their positions on the shaft. Replace the set screws and

remove the shaft from the pillow block, and file the flats as indicated by

the marks.

Chevron Shaft

Pillow

Block

Chevron

Mounting

Bracket

3. Position one end of the shaft, then the other, through the rectangular

cutouts in the chute wall.

4. Slide the pillow blocks over the shaft with the flats facing the set screws.

Tighten the set screws with an Allen wrench.

5. Fasten both pillow blocks to the bracket with3/8 " x 1 1/2" long bolts and

hardware (flatwasher, locking washer and nut).

Head Pulley

Chute Walls

Chevron Mounting Brackets

Chute Wall

Conveyor Belt

CHEVRON