ASGCO CHEVRON Panduan Petunjuk Pemasangan, Pengoperasian & Pemeliharaan - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan, Pengoperasian & Pemeliharaan untuk Pembersih Perhiasan Ultrasonik ASGCO CHEVRON. ASGCO CHEVRON 12 halaman. Belt cleaners

Halaman Cetak
ASGCO Mfg., Inc.
To adjust the Chevron to its proper cleaning pressure, push both Chevron
mounting brackets up until the discs start to compress against the belt.
Run your hand across the top of the Chevron where it touches the belt and
bend all of the discs in the same direction. Stop adjusting upwards on the
brackets when there is a 1/1 6" to 1/8" gap between the discs across the
width of the belt.
Note: Make sure gap is measured on top of Chevron, NOT on base belt.
1/16" to 1/8" gap between discs when they are compressed against the belt.
Note: the 1/8" gap should be measured with solid or notched disc on
surface of a Chevron.
CAUTION: Over-adjustment of the Chevron against the belt will result in
premature wear and under-adjustment will result in poor cleaning action.
Do not allow the discs to touch each other when bending them into
position.
When the Chevron has been properly adjusted, tighten the two nuts with a
slugger wrench so that vibration during operation will not cause the
adjustment to be altered.
Install a bearing cover on each bearing by stretching the 4" X 14" Neoprene
sheet over the top and under the pillow block Secure the cover by using
the bottom bolt extensions as locating pins. The bolts should protrude
through the holes in the Neoprene.
Pillow Block
9
14"
Neoprene sheet
CHEVRON