ASGCO CHEVRON Руководство по установке, эксплуатации и техническому обслуживанию - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке, эксплуатации и техническому обслуживанию для Ультразвуковой очиститель ювелирных изделий ASGCO CHEVRON. ASGCO CHEVRON 12 страниц. Belt cleaners

Печатать страницу

ASGCO Mfg., Inc.

To adjust the Chevron to its proper cleaning pressure, push both Chevron

mounting brackets up until the discs start to compress against the belt.

Run your hand across the top of the Chevron where it touches the belt and

bend all of the discs in the same direction. Stop adjusting upwards on the

brackets when there is a 1/1 6" to 1/8" gap between the discs across the

width of the belt.

Note: Make sure gap is measured on top of Chevron, NOT on base belt.

1/16" to 1/8" gap between discs when they are compressed against the belt.

Note: the 1/8" gap should be measured with solid or notched disc on

surface of a Chevron.

CAUTION: Over-adjustment of the Chevron against the belt will result in

premature wear and under-adjustment will result in poor cleaning action.

Do not allow the discs to touch each other when bending them into

position.

When the Chevron has been properly adjusted, tighten the two nuts with a

slugger wrench so that vibration during operation will not cause the

adjustment to be altered.

Install a bearing cover on each bearing by stretching the 4" X 14" Neoprene

sheet over the top and under the pillow block Secure the cover by using

the bottom bolt extensions as locating pins. The bolts should protrude

through the holes in the Neoprene.

Pillow Block

14"

Neoprene sheet

CHEVRON