ASGCO CHEVRON Руководство по установке, эксплуатации и техническому обслуживанию - Страница 4

Просмотреть онлайн или скачать pdf Руководство по установке, эксплуатации и техническому обслуживанию для Ультразвуковой очиститель ювелирных изделий ASGCO CHEVRON. ASGCO CHEVRON 12 страниц. Belt cleaners

Печатать страницу

ASGCO Mfg., Inc.

D. IF USING 10" DISCS WITH 1-3/8" OR 1-1/2" BEARINGS, measure the

distance to a point 8" down from (perpendicular to) the belt on the

chute wall. Mark this point "X'.

2. Transfer point "X' to the other side of the chute wall, making sure that the

two marks are in the exact same location on both sides. These marks

represent the location points of the mounting bracket bolt of the last

Chevron shaft. Keep in mind that they must be at least 10" away from

any pulleys or idlers mounted below the returning belt.

Head

Pulley

3. Use the illustration to determine the center to center distance of the

remaining Chevron bracket mounting points. The distance between

mounting points is determined by the diameter of the Chevron discs.

10" diameter discs require a 14" center to center distance between

mounting points. 8" diameter discs require a 12" center to center

distance. 6" diameter discs require a 10" center to center distance.

While moving towards the head pulley, mark the remaining mounting

point locations on both chute walls with "X" marks as was done in Step

1, following the course of the belt for the distance that the Chevron's will

be mounted.

4. On both chute walls, scribe a line parallel to the belt and connecting

each of the "X" end points. The intersecting points are the mounting

points for the Chevron assembly and must be identical on both chute walls.

14"

10"

14"

12"

10"

Belt Travel

Snub

Pulley

14"

12"

10"

CHEVRON