CYP PU-506-KIT Panduan Pengoperasian - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pemanjang CYP PU-506-KIT. CYP PU-506-KIT 16 halaman. 3-play hdbaset extender kit (2-way ir, rs-232 & hdmi, up to 100m)
Juga untuk CYP PU-506-KIT: Panduan Pengoperasian (16 halaman)
Halaman Cetak
6.2 Receiver Front and Rear Panels
Front
2
DC 5V
Power
Link
1
3
1
DC 5V: Plug the 5 V DC power supply into the unit and connect the
adaptor to an AC outlet.
2
Link: The yellow LED will illuminate when both the input and output
CAT5e/6/7 signals are connected.
3
Power: This green LED will illuminate when the device is connected to
a power supply.
4
CAT5e/6 In: Connect to the transmitter unit with a Single CAT5e/6/7
cable for transmission of all data signals.
5
RS-232 Out: Connect to the device that is to be controlled (with
the supplied 3.5mm phone jack to D-Sub 9-pin adaptor) by RS-232
commands.
6
IR1 Extender: Connect to the supplied IR extender cable for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR extender.
7
IR2 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line of sight of the
equipment to be controlled.
8
HDMI Out: Connect to a HDMI equipped TV/monitor for display of the
HDMI input source signal.
CAT 5e /6 In
4
Rear
IR1 Extender
RS232 Out
IR2 Blaster
5
6
7
HDMI Out
8
9