Cypress Envirosystems WPT-800-DB Series Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Termostat Cypress Envirosystems WPT-800-DB Series. Cypress Envirosystems WPT-800-DB Series 20 halaman. Wpt-db series deadband wireless pneumatic thermostat

Halaman Cetak
6.
Connect the branch and main tubes to the air tubes marked B and M on the rear
of the WPT-DB, as shown in Figure 6. Connect the pneumatic tube to the M port
in case of single pipe WPT-DB.
Figure 6. Connecting Main and Branch Tubes to M and B Ports
7.
Attach the WPT-DB to the Universal Wall Bracket using the captive screws.
8.
Install the batteries and close the top cover. The battery polarities are as shown
in Figure 7.
2.1.3
Installing/Replacing Batteries
Replace battery with Type CR123A, that meet UL-1642, as evidenced by UL
component recognition mark, only (from Panasonic, Energizer or Duracell). Use of
any other battery may present a risk of fire or explosion. See Figure 7 for correct
polarity.
•
Underwriters Laboratories Recognition Mark:
•
Caution: The battery used in this device may present a fire or chemical burn
hazard if mis-treated. Do not recharge, disassemble, heat above 100 ºC (212
ºF), or dispose of in fire.
WPT-DB Installation Manual
Document No. 910-00014-01, Rev. 04
Figure 7. WPT-DB Batteries
Page 5 of 20